HHSC will accept the following requests through the authorization request website. If you have any questions, please contact Dagny Schmidt at or email to askcm hhs. After receiving approval by HHSC to provide case management services, case management providers must complete a mandatory training. Monthly training is offered. Reduced-emission engine technology 2-stroke engine with stratified charge. Advanced combustion technology Four overflow channels swirl the fuel-air mix before ignition, allowing for optimum combustion and highly efficient performance.
Pre-separation air filtration system STIHL long-life air filtration systems with pre-separation achieve perceptibly longer filter life compared with conventional filter systems. Tool free fuel caps Special caps to open and close the tank cap quickly, easily and without tools. Decompression valve The decompression valve is part of the easy starting system. Side-mounted chain tensioning The tensioning screw can be found on the side of chain saw through the sprocket cover.
Owners manuals and safety brochures. Download PDF 4. Become a fan of: Youtube Channel. Tips Tool use and maintenance Garden Care Tips. Overdrive Solenoid Connector 2. Turn control switch to ON position. Overdrive Circuit Fuse Blown. Replace fuse.
Determine why fuse failed and repair as necessary i. Overdrive Clutch Pack Worn. Remove overdrive unit and rebuild clutch pack.
Check continuity with test lamp. Repair as required. Tighten fittings. Fill Tube where tube enters case 2. Damaged or worn threads in the aluminum trans- 6 Remove starter motor. Keep filter screws separate from other valve body screws.
Push valve body harness connector out of case. Then work park rod and valve body out of case Fig. Start pin through lever and out of case bore with The race is a permanent press fit on the hub splines.
Do not attempt to remove the race. Inspect the case for cracks, porous spots, worn 34 Compress rear servo piston with C-clamp and bores, or damaged threads.
Verify that thrust washers, thrust plates and seal rings are correctly positioned. Support shaft carefully during installation. Be sure gasket is properly aligned 12 Tighten front band adjusting screw until band with fluid passages in case Fig. Also be sure incorrectly assembled, or reaction shaft thrust fiber thrust washer is in position Fig. If rod will not 6 Move the transmission manual shaft lever to slide past park pawl, pawl is engaged in park gear.
Polish the hub and notches mounting bracket. Line pressure is directed to the small end of the piston when the transmission is The accumulator Fig. The double-wrap band pro- vides a greater holding power in comparison to the Fig. Engine starts must be possible.
Calibration of the pressure The governor pressure sensor measures output transducer offset occurs each time the output shaft pressure of the governor pressure solenoid valve Fig. The 1 Hoist and support vehicle on safety stands. PCM uses a temperature sensor in the transmission 2 Remove transmission fluid pan and filter. Trailer tow- tions which occur with a low fluid level. Page Inspection Also check action of the check ball in the piston there is any doubt about bushing condition.
The ball must move freely and not stick. Page Assembly Replace the piston if the ball is missing, or seized in place. Clearance between waved spring and pres- sure plate should 2. If clearance is incorrect, clutch plates, clutch discs, snap-ring, or pressure plate may have to be changed. Then remove piston rod, spring and washer from pis- ton. The latest version of the form was released by the U.
Department of the Army DA on October 1, DA Form must be completed by the authorized personnel no later than 7 days after receiving notice of said injury, illness, or disease unless the injury was not a direct result of Active Duty or IDT.
The form expires either in 60 days after the incident in case of an informal LDI or in 90 days in case of a formal LDI. The statement must be submitted within an adequate period of time for all allowances to come into effect within 30 days after reported injury, illness, or disease. The completed DA must undergo a detailed review and be approved by superiors for the continuation of incapacitation benefits.
0コメント